If necessary, switch between various modes of machine operation.
The procedure for configuring Custom Settings is as follows:
Custom Settings
Open the printer driver setup window
Make sure that the machine is on, and then click Custom Settings on the Maintenance tab
The Custom Settings dialog box opens.
Note
If the machine is off or if communication between the machine and the computer is disabled, an error message may appear because the computer cannot collect the machine status.
If this happens, click OK to display the most recent settings specified on your computer.
If necessary, complete the following settings:
The machine can increase the gap between the print head and the paper during high-density printing to prevent paper abrasion.
Check this check box to prevent paper abrasion.
Usually, the Print Head Alignment function on the Maintenance tab is set to automatic head alignment, but you can change it to manual head alignment.
If the printing results are unsatisfactory even after you execute automatic head alignment, execute manual head alignment.
Check this check box to perform the manual head alignment.
Uncheck this check box to perform the automatic head alignment.
Select this check box only if the machine is feeding multiple sheets of plain paper at the same time.
Important
Using this function slows down the print speed.
On the Page Setup tab, you can change the rotation direction of the Landscape in the Orientation.
To rotate the print data 90 degrees to the left during printing, select this item.
To rotate the print data 90 degrees to the right during printing, clear this item.
Important
Do not change this setting while the print job is displayed in the print wait list. Otherwise, characters may be omitted or the layout may become corrupt.
When you print from the computer, this function identifies the paper that was loaded into this machine.
When the paper width detected by the machine differ from the width of the paper specified in Page Size on the Page Setup tab, a message is displayed.
To use paper width detection when printing from the computer, select the check box.
Important
If you are using user-defined paper, use the Custom Paper Size to correctly set the size of the paper loaded in the machine.
If an error message is displayed even though the same size that was set is loaded, clear the check box.
You can set the length of the machine rest time until printing of the next page begins.
Moving the slider to the right increases the pause time, and moving the slider to the left decreases the time.
If the paper gets stained because the next page is ejected before the ink on the printed page dries, increase the ink drying wait time.
Reducing the ink drying wait time speeds up printing.
Apply the settings
Click OK and when the confirmation message appears, click OK.
The machine operates with the modified settings hereafter.
Page top
|
